Make two marks, and run a piece of masking tape horizontally across the two marks. The tape should be as wide as the vehicle plus an extra 2 feet per side. Park the car so it's exactly 25 feet from the wall to the face of the headlamps—don't estimate. Begin to adjust the low beam using the adjusters on the back of the headlight assembly so The headlight beam level is adjusted by an electric servo motor inside each of the headlights. According to the position of the adjustment knob of the headlight switch the electric servo motors will adjust the beam to the corresponding level. Just position the car in front of a wall with the lights on. This is a quick video showing how you operate various switches on my Ford Focus.www.andrewknightdriving.org.uk This video I go over how to dim and writing the lights on in the instrument panel in a Ford focus 2017. This same operation can be applied to several other F For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall. The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support. Turn the headlights ON and mark the wall at the center of each light's low beam, then switch on the brights and mark the center of each light's high beam. A short length of masking tape which is visible from the front of the vehicle may be used. Although marking all four positions is advisable, marking one position from each light should be XURkXUN. *Edited title to show more accurately what i'm doing here. thanks to suggestion for that help.I took some time to replace the headlights in my 2000 ford focu With the lights set to "left" the beam pattern should be flat on the right side with a diagonal kick-up to the left. This is the correct setting for the UK and Ireland as the kickup lights up road signs etc on the side of the road while the flat part on the right avoids dazzling oncoming traffic. For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall. The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support. Put a blanket or an item of clothing over the headlight you aren’t adjusting. Turn the lights off and use a screwdriver to turn the screws until the headlight is at the level you require. Turn your headlights back on to see if further adjustment is required. There should be a screw to adjust the lamp vertically and another screw to align it Adjust the Aims with the Markings on the Wall as a Guide. Now that you’ve distanced the truck and located the adjusters, you can now adjust the headlight aim. First, block a single headlight and see where the other beam reflects relative to the lines you’ve drawn on the vertical surface. For vertical aim, the upper part of the beam’s most Not sure about how high your headlights should be aimed? This short video shows a super easy way to adjust your headlamps so they're aimed right where they n

how to adjust ford focus headlights